Important: Do not leave the ISE soaking for more than 24 hours. Important: Do not fully submerge the sensor. Slide the cap onto the electrode body, and then screw the cap onto the storage bottle so the tip of the electrode is not touching the sponge.When you are finished making measurements, rinse the electrode with distilled water.For best results, perform a two-point calibration using the High and Low Standard solutions.Connect the sensor following the steps in the Getting Started section.Make sure no air bubbles are trapped below the ISE.The small white reference contacts near the tip of the electrode should be immersed.The ISE should not rest on the bottom of the container.Soak the tip of the electrode for 30 minutes in the High Standard solution.Thoroughly rinse the lower section of the probe using distilled or deionized water.Remove the storage bottle from the electrode by unscrewing the lid and removing the bottle and lid.Refer to the Using the Product section for more information.Īnalysis 4 on your computer or Chromebook. Prepare the electrode by soaking it in the High Standard solution for 30 minutes.Perform a two-point calibration using the High and Low Standard solutions. The Bluetooth LED will blink green when it is successfully connected. Your sensor's ID is located near the barcode on the sensor. Click or tap your Go Direct sensor from the list of Discovered Wireless Devices.Refer to the Using the Product section for more information.īy pressing the power button once. Prepare the electrode by soaking it in the High Standard solution for 30 minutes.Please see the following link for platform-specific connection information:Īnalysis 4 on your computer, Chromebook™, or mobile device.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |